Thanks for all of the comments, this has been very helpful.
I would send Wenig my stock to have it duplicated.
Does anyone know how the inletting is done? I was thinking it's done using a jig, so if even if my stock was duplicated, if the inletting was done based on another gun, it may not fit properly.
I'm not planning on finishing it myself. I've done some woodworking and refinished a couple of my garands, i just don't think I have the skillset to do it right the first time and get it to match my forend which I luckily don't have to replace.
|
Threaded Mode