Doozy of a query!

[Sean Harper]

A big thanks to everyone that has helped to educate me on my Parker! I have learned so much and certainly could not have done anything without you wiseguys. This thread is getting a bit long in the tooth so I'll be opening up a new one in the restoration forum.

I just have one last issue I need assistance with. I have removed every available screw from the stock and now I am ready to pull the hinge and bottom plate off. This is a lifter so the bottom plate is stuck on it. And, the crown of the metal on top is protruding just right to inhibit removal. So, what I have now is an almost dissasembled stock with the triggers and hinge plate wobbling around. How do I procede? Have I missed anything? I hope you can tell by the picture what a state I am in. I am so close! Anyone dissasembled one of these before?

Any help would be greatly appreciated.

Sean

[Harry Collins]

Sean,

It has been a while. If you push the lifter up a little you will see the linkage between the stock and the receiver move. There is a small screw that connects the lifter to the locking bar. It will be on the left side as I remember. Unscrew that small screw and things should come apart.

Harry

PS: Austin is the "WIZARD" on lifters.