Rst reloading

[B. Dudley]

Here is the RST wad that I took out. The same in both shells. I know that the other thread mentions using IMR PB powder. My local shop does carry IMR powders. I see 700x is also made by IMR.

image.jpg

[C.O.B.]

Ok here I am the holiday is over I have eated to much and NOT washed it down with an over indulgence of adult beverages as I had to drive to Grandmas house and back.

Brian I load only RST 2.5 inch hulls in 12,16,&20. If memory serves I'm using Clays powder in the 12 and Galandi wads in everything. If you would like specific data please PM me and I'll provide it.

The 2.5 inch shell can't be loaded on a Grabber but Mec will make you a 9000 (maybe a Grabber I didn't ask) for the shorter hull. I have one for 16's and will order another for the short 20.

[George M. Purtill Member #28]

Originally Posted by Brian Dudley

Here is the RST wad that I took out. The same in both shells. I know that the other thread mentions using IMR PB powder. My local shop does carry IMR powders. I see 700x is also made by IMR.

Attachment 20670

Who makes that wad?

[Frank Allegra]

Originally Posted by Brian Dudley

Here is the RST wad that I took out. The same in both shells. I know that the other thread mentions using IMR PB powder. My local shop does carry IMR powders. I see 700x is also made by IMR.

Attachment 20670

Brian, I think Daryl is correct about it being a Gualandi wad. Here is a photo of the SG16 for comparison.