H. Goodman St. Louis Mo.

[David Noble]

Thomas, what an unusual and interesting contraption that is!
How do you pluck the shells out of the chambers?
How difficult is it to cock the hammers by openning the breech? There's not much mechanical advantage there.
The firing pins must be enertial, and spring loaded or it would be difficult to open the breech. (they'd be stuck in the primer indents). I've got more questions but will stop here.
Thanks for sharing!

[OLD GEEZER]

I will take a few fhoto's tonight and show the breech and how it goes together. It is a unique set up that is for sure. Thomas

[OLD GEEZER]

Here are a couple photo's of how the barrels attach to the receiver.As you can see they just slide on and a bolt is slid in with a retaining screw. After you fire the gun you just pull the lever on the side and the breach pops up. Then if you pull the breach all the way back it extracts the shells and also cocks the hammers.If you don't want the hammers cocked you just release by holding the triggers back and putting the breach back down.I may not be calling them by the right names but I hope you get the idea. The barrels are 28 inches long.Thomas