Precision Reloadins Brass Adapters for short shells

[Paul Harm]

I've found the short kit very easy to install, although the Precision kit also sounds nice. Is there something you don't like about the short kit ?

[6pt-Sika]

The short kit works nicely on my 10 gauge loader but these little brass things are used just on the crimping stations . And you can slide it back and forth with the shell in it .

Matter of fact the 12 and 20 gauge ones are on the way to me as I type this !

I've also already spoken with someone about making me something similar for the 16 gauge !

[6pt-Sika]

Of course if I had boatloads of money I'd call Ponsness Warren and get them to make me 800's for the 2 1/2" 12 , 16 and 20 as well as a 2 7/8" for the 10 gauge .

Or better yet just order pallet loads of shells from RST

[6pt-Sika]

Originally Posted by Paul Harm

I've found the short kit very easy to install, although the Precision kit also sounds nice. Is there something you don't like about the short kit ?

Since I'll be loading both 2 1/2" and 2 3/4" off the same press this thing means you don't need to change anything !

I do not argue the point that the short kits are easy enough to install however , this little brass thing Precision Reloading markets is nothing more then a movable spacer for the crimping stations .