Ed Kettner Drilling 10.75x65R Collath

[6pt-Sika]

Originally Posted by Mark Landskov

http://www.buffaloarms.com/Detail.as...56857&CAT=3831

Buffalo Arms has brass from Bertram. It is not cheap, but it is the proper size. Buffalo forms a lot of their brass. I try to buy them before I settle for Bertram. Dies can be spendy. I just bought a set of CH dies for my 43 Dutch. The brass is formed from Starline 50-90. Good luck!

For the 10.75x65R Collath there's no reason to buy from them . A slight trim of Hornady 405 WCF brass , runn the case in the 444 resizer to open the neck put a charge in load the bullet fire it and it's fire formed .

The dimensions of the 25-35 WIN and the 6.5x52R are almost exact so again no reason to buy the expensive stuff .

Heck I think it's bad enough buying 50 pieces of Hornady 405 WCF for $47 .

[6pt-Sika]

Incidently , when I finish with this one I'm gonna drag out the hammerless Kerner drilling we have . That ones 16-16 and 7x57R . This one should be a breeze !

On a kinda side note . Two days ago I came in contact with a very nice J.P.Sauer 12-12-7x57R thats for sale . Just might add that one to the accumulation !
I believe this gun to be post WWII from the late 50's to mid 60's although the engraving is bery nice on the gun !
It has a very nice scene on one side of a Roe Buck with a couple dogs and then on the other side it has a pair of Caparacialle (not sure if I spelled that correctly).