Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I got an oversized plastic reproduction butt plate for the LCSmith I'm fixing up. The curvature doesn't match. Approximately how long does it take in boiling water to soften them enough to bend?
Just completed installing a spur butt plate on a Parker and I used the wife's hair dryer to get curve right and it worked great. Just heat maybe 30-40 seconds both sides and it remains workable for a minute or so.
The Following 2 Users Say Thank You to Scott Gentry For Your Post:
Threaded Mode