[quote=Jack Cronkhite;46309]Progress thus far:
Trigger plate removed, disassembled, gunk and rust completely eliminated, cold blued, lightly oiled and hand rubbed, re-assembled and ready to go when the rest is done. If the pin and the lugger (extractor blade ) are OK, and they are silver soldered into position on the lugger- I would have a machinist make a new shank with the key-way, right to scale from D-2, and refit it to the guide pin and lugger- if you put heat into the ejector assembly, heat always travels to the thinnest mass- overheating might cause the silver solder to break lose anyway=-- it some ways, it is way easier to straighten dents in a pipe (shotgun barrel_) than to bend back a out of alignment solid rod, no matter the metallurgy
R and R on the shank and maybe alignment pin
Hybrid Mode