Trigger Guards

[10 bore]

Originally Posted by Elvin Ehrhardt

OK. Can I ask your advise for a possible alternative? Is it possible to construct one using a pistol grip type guard and welding some steel stock as an extension onto the guard?

I have done it, i used coldroll welded to flat stock ,traced a factory trigger Guard on it shaped it to that and it came out very good. I never colored it so i don't know if it would have matched the front factory part of the guard. I did it for a restock 10 ga.

[Elvin Ehrhardt]

Thanks Scott. That's basically what I was planning to do. My only difficulty is although I have a half dozen Parkers, this 10ga that I'm working on is the only straight stock I have right now. This leaves me without a pattern to work with, but I believe that using the inletting on the gun and screw hole positions along with some good close-up photos from mother straight stock Parkers will guide me to a workable solution.