Information on 10 gauge frame size 4?

[Zac Gallus]

Originally Posted by CraigThompson

That number isn’t in the serialization book . I’ve had two 4 frame 10’s the first was an 0 grade 34” and the one I have at present is a Grade 2 32” both are top lever hammer guns .

The one I got is also a Grade 2 top lever hammer but not sure on the length. Will measure when I get home

[Bill Murphy]

We are getting comments from more than one poster. "Bottom of the barrel" does not describe the location of the frame number marking. The bottom of the rear locking lug is the location of the frame number. The "locking lug" is in the middle of the two barrels.

[Zac Gallus]

Originally Posted by Bill Murphy

We are getting comments from more than one poster. "Bottom of the barrel" does not describe the location of the frame number marking. The bottom of the rear locking lug is the location of the frame number. The "locking lug" is in the middle of the two barrels.

Sorry, that's what I meant. The "4" is on on the barrel lug as shown on the Technical Information page on this website.