Parker Gun Collectors Association Forums  

Go Back   Parker Gun Collectors Association Forums Non-Parker Specific & General Discussions General Discussions about Other Fine Doubles

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
HE Super Fox
Old 09-22-2025, 12:46 AM   #1
Member
Frank Good
PGCA Member
 
Frank Good's Avatar

Member Info
 
Join Date: Jan 2024
Posts: 100
Thanks: 288
Thanked 331 Times in 65 Posts

Default HE Super Fox

I picked up this 1923 mfg HE Grade, 27xxx serial #, 3" chambers.

The good? Overall the gun is in good condition. Bores are shiny, no pits or dents. Very little colour left on the receiver or outside of forend iron but some left on inside of forend iron. Bluing is very good still with a bit of wear around the muzzles. No pitting or rust on the barrels. Gun locks up tight. Wood is good with a few marks from a lifetime of hunting but no cracks, chips or pieces missing. Checkering is still crisp and the Hawkins pad is not crushed or dried out and cracking. Screws are still timed perfectly and not chewed up. Top lever sits just a little right of centre still. Engravings and barrel stamping is still crisp and sharp.

The bad? Someone shortened the 30" barrels to 28" at some point. I'll have to mic them to see if there is any constriction left. Looking down the inside of the barrels there appears to be an inch or so back from the muzzle where the bore diameter appears to still have some choke taper. There is plenty of meat left for a set of Briley thin walls and I may go that route. There is a few tiny pit marks in the receiver on the right side but the rest is good. The trigger guard bluing is faded in comparison to the barrels and completely worn off on the tang but the engraved serial # on the tang is not worn. The ejector rods have been removed and the previous owner did not have them or even realized they were removed. He never fired the gun. The auto safety(if they were made with one) has also been disabled. It's manual only. The pistol grip cap appears to have been set on or near something hot at one point as it appears to have a divet melted into it but is still intact and fits the pistol grip perfectly.

A good cleanup and a few repairs and this should be a good shooter. Collector status is gone but I wanted a good robust waterfowling piece and at 1/4 the price of an unmolested collector and in Canadian $ not $US this will fill that niche quite nicely! I'll post better pics tomorrow when I have better light.
Attached Images
File Type: jpg IMG_8796.jpg (468.3 KB, 5 views)
File Type: jpg IMG_8797.jpg (479.8 KB, 6 views)
File Type: jpeg IMG_8781.jpeg (149.8 KB, 15 views)
Frank Good is offline   Reply With Quote
The Following 4 Users Say Thank You to Frank Good For Your Post:
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:20 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Parkerguns.org
Copyright © 2004 Design par Megatekno
- 2008 style update 3.7 avec l'autorisation de son auteur par Stradfred.