Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
The 600jr will resize the brass properly but I found the hulls are difficult to remove from the die. I resize my 10ga hulls on a MEC Super Sizer.
If you remove the resizing die, you can loosen the nut, lengthen the depriming shaft and the hulls will just pop right out. Don't forget to retighten the nut on the depriming shaft when adjusted.
Threaded Mode