Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
First, are you sure it was threaded in and not a taper fit?
If it is indeed threaded, use a machinist’s small “easy out”.
Drill the smallest hole that will allow the easy out to start in,
Then tap it in a tad, just enough for it to get a bite and use a tap wrench to turn it out counter clockwise.
The Following 2 Users Say Thank You to David Noble For Your Post:
Threaded Mode