CHE factory ejector modification?

[edgarspencer]

Interesting to note, that both fore end irons, which were extractor, were used in the conversions, but it appears they were done by two different men. I do remember when the gun was at the NE SxS, the fore end, whose hammers move fore and aft, was troublesome, But until just now looking at the pictures, don't remember the other fore end.

[B. Dudley]

Originally Posted by edgarspencer

Interesting to note, that both fore end irons, which were extractor, were used in the conversions, but it appears they were done by two different men. I do remember when the gun was at the NE SxS, the fore end, whose hammers move fore and aft, was troublesome, But until just now looking at the pictures, don't remember the other fore end.

Edgar,

I do recall seeing a gun very similar to this one. A C grade with floral engraving. But do not think it was this one. I recall it being in original condition and not having aftermarket ejectors. I think Larry Frey may have had it.

[edgarspencer]

Originally Posted by Brian Dudley

Edgar,

I do recall seeing a gun very similar to this one. A C grade with floral engraving. But do not think it was this one. I recall it being in original condition and not having aftermarket ejectors. I think Larry Frey may have had it.

You’re partly correct Brian, it was Larry, who had it at Haussmanns. I don’t specifically remember the condition, as much as the lack of rib extensions and aftermarket ejectors. His wife shot it with us on the lower course, and Larry said it was giving her trouble.

[Double Play]

Edgar and Brian are correct, I did own this gun for a short time but sold it on this site six years ago to another member. It was my belief that the first set of barrels were cut to 26'' possibly due to damage and a second 30'' set was ordered as per the letter. I seem to recall the barrel wedges were installed in the short barrels which could mean the work was done at the factory but it was not referenced in the letter so who knows. I have not seen the gun since the Turnbull restoration so if another member gets it hopefully, I will get to see it again someday.

[edgarspencer]

I have no doubt many would take exception to this, but if it were my gun, I’d do away with both fore end irons, and return the gun to its original state, as an extractor gun. I don’t feel that the after-market ejector system adds any value to the gun.