I silver soldered 1/2 of a 26 LPI cutter to a round bottom tool. I ground 1/2 the 26 LPI cutter off, took two of them actually as you need a cutter on each side. I like to travel left to right when I checker so my left side is smooth, it doesn't cut as it needs to ride in the border that was cut when the pattern was cut. It works great! It's a pain in the rectum to make however, took nearly 4 hours! I have it now however so I guess it's worth it. This thread prompted me to give it a go and it turned out pretty darn neat! Jerry
|
Threaded Mode