Roll Crimping

[Cory Rams]

I almost passed on the drill to begin with but grabbed it because it was laying next to the press. Your right about that press. It’s built like a tank. Figured it will outlast me. I looked at some of modern presses that accept a drill. They look like dollar store imports that would probably not make it through a session of crimping before it failed.

[edgarspencer]

Corey, I can't remember if you said, but you may be better off with a newer drill if you're rolling plastic hulls. Speed helps get the case lip warm for a nice turnover, and as well as they were made, the older corded drills don't turn up all too fast.