Reloader advice 28 ga

[Bill Murphy]

To eliminate all the troubles with rag tag, finicky collet sizers, buy a Ponsness Warren 375, the best single stage loader on the market. I bought my first one when I was about 15 years old and am still using it, and a couple of others, sixty years later. The full length sizer cannot physically let a shell out without it being fully sized. The collet sizers just plain don't work with some chambers.

[Dale Medders]

Well I have a 600 JR and loaded all my 28 ga Win AA HS hulls no problem.
Started loading my Win AA Compression hulls and at the depriming station the hulls would jam tightly in the primer punch shaft and need a hammer and pliers to remove. After several trips to the belt sander to reduce the large part of the primer punch diameter they finally started to release. And yes I spent several hrs moving punch height up and down and every adjustment I could only solution was removing a fair amount of that punch diameter.

[Pa SxS]

I had a Mec Grabber. Only issue was an occasional shot bridge. Makes quite a mess when it breaks loose! Yes, it was magnum shot.

[Mike of the Mountain]

I use a 600 JR for 2 3/4 and 2 1/2" 28g. No issues at all.