Black powder/smokeless?

[Roberto S Siciliano]

Dean... what is deemed a safe wall thickness?
Thx

Originally Posted by Dean Romig

Smokeless is not “off limits” even for the oldest of Parkers. It is the chamber pressure that we need to consider. If the barrels and barrel wall thickness is deemed to be safe you can shoot anything with pressure of probably about 8,000 (or less) psi and muzzle velocities of less than 1,250 or so fps. A lot of us use RST Classic Shotshells. Look them up and check out their website for a very decent listing of all the shotgun anmo they load for our classic shotguns.
But the stock, being 100 years or more old is another consideration entirely. Cracks, splits and chips can and do occur.

“Low brass” really means nothing. It all depends on how the shell is loaded. I’ve seen some pretty stout loads in low brass shells.





.

[Dean Romig]

Originally Posted by Roberto S Siciliano

Dean... what is deemed a safe wall thickness?
Thx

Most classic SXS folks believe .025" wall thickness to be the minimum for safe shooting.



.

[Drew Hause]

Dean's answer would be the short version and it's a lot more complicated.
Since I've never found engineering drawings or specifications by ANY U.S. maker for wall thickness, the recommendations are based on lots of measurements of presumed to be unaltered barrels.
http://parkerguns.org/pages/faq/BarrelThickness.htm

Never missing an opportunity to rant , sellers commonly list MWT, never bothering, or not disclosing, end-of-chamber and 9" numbers.

Consider this