I have placed an order with Reloaders Network for a 10, 12, 16 and 20 crimpers and some other accessories. The BPI one I had for 20 gauge just didn’t work(for me anyway) the 16 gauge from Precision is okay, but not great in my opinion. I have original hand crank crimpers for 10 and 12 which work well. It will be nice to have some quality tools for this.
However, I just bought a nice little English sxs 12 gauge 2” gun and the hand turn crimper will not crimp shells that short. The shortest I could go is 2 1/8” which work well in the gun and I can still put a nice roll crimp on them with my hand turn crimper. I am looking forward to real nice drill roll crimper so I'll be able to make 2" shells.
On that “new” 2-inch 12 gauge, I have been having so much fun with it. I had to make some shells for it and since there is not a lot of room they need to be roll crimped. Here are some I made with an original hand turn roll crimper.
The 50 on the left are new cut hulls and my 9 year old daughter likes to decorate the overshot cards. The upper right are once fired 2 1/8” shells that I have already shot once. And the bottom right are cut once fired 2 ½ RSTs. We had fun making these…
I am using a Gualdini light brush wad, 3/4oz of shot and 14.5 grains of Red Dot. I’ll likely drop down to 14 grains when I reload these at 2”(just so I can have a little more room in the case and make a real 2” shell). The RST 3/4oz 2” is going at 1100fps, so I think I will be around that velocity.
|
Threaded Mode