Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
The principal component of the short kit is the 1/4” spacer plate, so I just move it over to the 12ga. press when I load 12s. If I recall, the kit also has a spacer ring for the primer seating cup, and, there again, I just swap that over. I roll crimp all my 28ga. so, not using the final two stages, I don’t need the short kit on that press. I only load 2 1/2” now.
Threaded Mode