The dreaded "Is shotshell reloading worth it" question

[Harold Pickens]

I believe I got my short kit from Precision Reloading for about $30. I ordered one for a 16--and it also works on my 12 and 20 Mec 600 jr.
Now, just my opinion mind you--thru a Parker fluid steel 12 ga, I dont shoot short shells, I have loaded some, then gave all my 2 1/2" hulls away. Most of my 12 ga are 7/8 oz mild pressure about 1150 fps--shoot those also in my Greener sidelever damascus also, I use green Rem Gun Club hulls. I have a few cases of 12 ga game loads with 1 oz shot, I shoot those also in fluid steel guns.
In 20's, I used to load 2 1/2", but now just shhoot a mild 3/4 oz load using 20/28 powder in AA's and Gun Clubs. Makes life simpler. In between guitar playing this morning, I loaded 2 boxes of that 20 ga load--I dont hesitate to hunt grouse with it either.

[edgarspencer]

The principal component of the short kit is the 1/4” spacer plate, so I just move it over to the 12ga. press when I load 12s. If I recall, the kit also has a spacer ring for the primer seating cup, and, there again, I just swap that over. I roll crimp all my 28ga. so, not using the final two stages, I don’t need the short kit on that press. I only load 2 1/2” now.