Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Hold the cavities over a candle to cover them with soot, it will act as a release agent. After that, just run a lot of balls out of it to make sure it is up to temp. I've never cast a ball that large, but you will probably go through many balls before it will start casting perfect ones. It will take time to bring the mold up to temp. The more you use the mold, the easier it will work. Good luck.
Threaded Mode