Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
The reproduced DHBP's that I have tried (3) are slightly under sized with the hole spacing a little short. These are no. 1 size. Two are made from the same mold and were not good examples to be using for that purpose as they have the same defects, small chips and the sides are not right. It would be nice if we had a source for better made ones. I had rather fit the plate to the stock than fit the stock to the plate. If someone had a good example to use to make a mold would it ruin it to use it?
The Following User Says Thank You to Gerald McPherson For Your Post:
Hybrid Mode