Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Well I started my first relay job gun had a loose top rib so I will give it a try. Did the P Brothers fill the void between top and bottom rib with a type of putty before soldering ? When I removed the rib this was packed in between the two. My bottom rib is tight should I remove and redo also ? I dont see any spacers either . Does the bottom rib start and stop at forend lug and start again to the muzzle
0 grade Rib Relay
Threaded Mode