Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Same with me , was sizing my Cheddite 16s in a PW 375 priming then knocking out with a custom knock out rod. Then finishing on a MEC 600 with the short kit. MEC alone the rims often bent when sizing. Since have fully converted 16 loading to the PW which supports the hull full length while sizing. MEC size master would do the same.
Threaded Mode