Quote:
Originally Posted by William Davis
Here’s a question for PW experts.
You think the short parts would mount back side requiring a head reverse to use & not affect the full size shells loading.
Willam
|
I'm no expert but "the short parts" consist of a shorter sizing die and a shorter wad guide stop. Neither of those "short parts would mount backside." The sizing die slips in and out of the sizing die holder through the last station hole in the loading plate and the wad guide stop is changed by removing the wad guide and exchanging the long one with the short one. The only thing you would gain by mounting an additional set of dies on the backside of the tool head is the time it takes to adjust the two crimping dies -- the dies for 2 3/4" and 2 1/2" shells are exactly the same -- you just adjust them to suit the length of shells you are loading.
Threaded Mode