Quote:
Originally Posted by Ronald Scott
Just got off the phone with PW. I called the main number and spoke to the person who answered. (Didn't have to get transferred to technical support or the machine shop.) She knew immediately what I needed. All you need is two parts to load 2 1/2" shells -- a cut down sizing die (aka shell holder) -- $37.50 and a wad seating sleeve -- $4.85. Total additional charge -- $42.35 You do have to call for these 2 parts as they are not on their website.
Now I just need to find some decent hulls -- not sure I want to bother peening the primer pockets every time I reload.
|
Ron,
I use RST hulls for my 12 and 20 gauge 2 1/2" loads with Winchester primers. There doesn't appear to be a loose fit problem with that combo.
I load them about 4 times and toss them as a cautionary move because of the inside base wad. I haven't had a problem but just being cautious.
I have some extra RST hulls if you'd like to try some. Just pay postage. 12's and 20's.
Anybody else also.
Bill
Threaded Mode