Quote:
Originally Posted by Bill Murphy
"Looks like" doesn't cut it. Milton has a very curious mind, brings up some great ideas, but he needs to invest in a Vernier caliper and give up on the "Looks like". Parker made 3 1/2" chambered tens before the advent of the Super X loads. I have a #6 frame PH that letters as a factory 3 1/2" gun and I'm sure they made a few #3 frame 3 1/2" guns before the Remington era also. I'm not sure if my #6 frame ten PH predates the Super X loads. I have seen 10 gauge Damascus barrel English guns that went through nitro proof with modern 3 1/2" shells also.
|
I had one years ago because I had thought of sending the Zephyr to Briley for chokes and needed to measure the muzzle diameter to determine for thin walls or regular chokes .
I have seen English ammo catalogs that predate the 10 ga 3.5" Super X of the 1930s . They were 1900s or 1890s catalogs that listed the 10 ga from any length up to 3.5" . Actually They may have listed one longer than that .
I dont doubt that a #3 frame Parkers could handle it . The CG Bonehill I owned had 3.5" chambers though I only shot RST 2 7/8s out of it . The guy I sold it to ran alot of 3.5" shells and never had a problem. That was a heavy barreled gun to start with .
Threaded Mode