!4th Annual Addieville Fun Shoot

[BRDHNTR]

Dean, I guess it will be you, the kids, Edgar and me. Have not heard from anyone else. By the way, the damascus barrels arrived today and i took them over to Dan C. Only minimum fitting will be required. They practically slid on. Only issue is the chambers were reported to me from the seller as 2 5/8 but after Dan measured them they are actually 2 1/8. Dan indicated there is plenty of metal to open the chambers to 2 3/4 's. Since i only shoot light loads there is no issue except the extra cost to open them. Barrels are clean, excellent condition

[edgarspencer]

I’ll be there also, Allen.

With regard to those Damascus barrels, I would not do anything until I got a letter. It would be highly unusual for them to measure 2 1/8”, and if you were following another current thread regarding barrel measurements, Dr Drew shows a cross section of the chamber. The beginning of the forcing cone, moved forward 1/2” May yield a very thin wall section.
If the gun is actually chambered for shells of about 2 1/4”, it is almost certain to be a special order.