Reloading and short chambers

[Paul Harm]

I've been busy - going to Bachelders with Mark [ where I got a 10ga from Mark before he let Brad see it ] and getting ready for our leagues dinner out at the club. Haven't measured the barrels in the "new" 10 yet- but did have to get the right barrel to cock. The trigger was staying up just a hair. The gun had been restocked so I'm thinking the difference between the top tang and the trigger plate was a bit closer togeather causing the problem. Waitng for a top lever spring from Brad- when that comes I'll put it in and class-bed the reciever and stock [ a small gap there ] - remove a dent in the barrel,and it'll be ready to shoot. I'll measure the bore, chamber and chokes to see what they are. Paul

[Roundsworth]

Paul, my 10 gauge has also been restocked. It looks pretty good, but it wasn't mated flush/flat to the rear of the receiver. I will have to do a bit of bedding to fix that. I may also have a top to trigger plate issue like yours.