Good will stops where dangerous..."smoke"...starts, and those numbers make no more sense that "axial shaft located in the receiver".
If they refer to the end of the chamber or just past the forcing cones, the 2 1/2" and 2 3/4" numbers are below the CIP recommended wall thickness for Category 1 “Standard Steel” (Non-alloy AISI 1045) with tensile strength = 101,526-123,137 psi. Are your numbers at 6"??
How many of the British boxlocks that you disassembled had wall thickness to match your numbers Craig?
Last edited by Drew Hause; 12-20-2018 at 12:35 PM..
|
Hybrid Mode