|
 |
 |
||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||
 |
 |
09-24-2010, 10:24 PM
|
#3 | ||||||
|
Jack, I use Polywad Vintagers with 7-1/2 shot. These work nicely in my Damascus LeFever. They should perform admirably in the Lifter. Cheers!
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' |
||||||
|
|
||||||
 |
 |
 |
| The Following User Says Thank You to Mark Landskov For Your Post: |
|
|
|
09-25-2010, 09:10 AM
|
#4 | ||||||
|
Mark,
Brad does nice work. He just did a set of barrels for me after he had fitted them to a frame I had lying about. I could not have been happier. I'll post pictures when the gun comes back from the stocker. Harry |
||||||
|
|
|
||||||
|
|
|
|
|
|
09-26-2010, 01:44 PM
|
#5 | ||||||
|
Here is what it looks like. I really don't have a proper set-up for good photos, so I have to rely on sunlight, flash or available lamps.
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' |
||||||
|
|
|
||||||
|
|
|
|
|
|
09-26-2010, 04:33 PM
|
#6 | ||||||
|
Here is the other side. I wrapped a .004" shim around the hinge pin to bring the barrels back 'on-face'. I also greased the hinge and forend iron with some Gunslick Gun Grease. Pert near as good as new! I will try her out tomorrow morning. Cheers!
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' Last edited by Mark Landskov; 09-26-2010 at 06:09 PM.. |
||||||
|
|
|
||||||
|
|
|
|
|
|
09-27-2010, 02:53 PM
|
#7 | ||||||
|
I ran a box of Polywads through the Lifter this morning. What a blast! She's a 'keeper'!
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Mark Landskov For Your Post: |
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode