|
 |
 |
||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||
 |
 |
09-23-2010, 08:19 PM
|
#3 | ||||||
|
Mark, Have you measured the bore's?
__________________
"Much care is bestowed to make it what the Sportsman needs-a good gun"-Charles Parker |
||||||
|
|
||||||
 |
 |
 |
|
|
|
09-24-2010, 06:12 AM
|
#4 | ||||||
|
Dave, I do not have the proper equipment for measuring bores. In fact, UPS should be dropping the barrels off today or Monday. They were restored by Brad Bachelder. He may have included a set of 'before and after' measurements. The barrels were literally sewer pipes and required a bit of reaming to clean them up.
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' |
||||||
|
|
|
||||||
|
|
|
|
|
|
09-29-2010, 01:36 PM
|
#5 | ||||||
|
The Parker Story states that the 'diamond P' is unknown. My 1877 Twist barrels have a 'diamond P' on one barrel, ahead of the flats. My 1879 Laminated barrels have 'diamond Ps' on both barrels, AND a 'plain P' on the right flat next to the weight. Is the 'plain P' supposed to indicate Parker made barrels, or is it the 'diamond P'?
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' Last edited by Mark Landskov; 09-29-2010 at 06:18 PM.. |
||||||
|
|
|
||||||
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode