2k Nitro 27 hulls to use

[Bill Graham]

I haven’t had primer seating issues either, and am not generally fearful of 2 3/4” in 2 1/2” guns. However, since there are British guns in the mix with 2 1/2” chambers, it might be appropriate to have a 2 1/2” solution available. Probably doesn’t matter there either, but learning new solutions is a good thing.

[Kensal Rise]

Originally Posted by Bill Graham

...since there are British guns in the mix with 2 1/2” chambers, it might be appropriate to have a 2 1/2” solution available. Probably doesn’t matter there either, but learning new solutions is a good thing.

None of the 26 British guns I have in the gunroom with 2 1/2" chambers seem to mind 2 3/4" cartridges. And haven't for decades.

[Pa SxS]

I have problems with all Remington hulls and primers not seating flush no matter the gauge whether using Remington or Winchester primers. These are once fired hulls and using MEC reloaders. After the 1st or 2nd reloads the primers seat flush and yes, the primer seating station is adjusted properly. Never have the same problem with Winchester or Federal hulls.