Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Robin, the method Brad used is the same as what is done in England. The bored out chamber is usually to the cartridge rim diameter. Rather than a square shoulder, the barrel tube has a very slight champher from the smaller diameter to the large diameter. This then gives a V groove weld prep.
The Following 2 Users Say Thank You to edgarspencer For Your Post:
Threaded Mode