Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
I use the 19 grain 1&1/8 oz Red Dot load in my Cheddite hulls. Either the Cheddite primer or Winchester. ( My average drop with MEC bushing is 18.6 grains) Load works very well. I also use this with Federal and Remington hulls. My 2 short ten's are not choked all that tight but they can break clays pretty far out there. Just a very nice low pressure load that works!
The Following User Says Thank You to Eric Johanen For Your Post:
Threaded Mode