I finally have everything disassembled. There was quite a bit of rusty dirt/dried up oil/sweat deposited in every nook and cranny! The hammer and tumbler assemblies rock back and forth in the sideplates, ever so slightly. When measured with a digital caliper, I could find only .0005" difference between the hole and the shaft! I thought they would be all tuckered out. There is an awful lot of steel in this gun! Very well built. The original order tag is available for it, too. I just mailed off my dues for the PGCA and will be looking forward to the newsletters. Cheers!
|
Threaded Mode