|
 |
 |
|||||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||||
 |
 |
11-17-2016, 09:08 AM
|
#3 | ||||||
|
Not all that difficult.
__________________
B. Dudley |
||||||
|
|
||||||
 |
 |
 |
| The Following User Says Thank You to Brian Dudley For Your Post: |
|
|
|
11-18-2016, 12:27 PM
|
#4 | ||||||
|
Did you check to see if the extractor seats properly into its recessed cut out?
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Mike Franzen For Your Post: |
|
|
|
11-19-2016, 07:07 AM
|
#5 | ||||||
|
Evidently it can not go either way...
He must be talking about the bolt. It must be in upside down. 
__________________
B. Dudley |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Brian Dudley For Your Post: |
|
|
|
12-02-2016, 11:58 PM
|
#6 | ||||||
|
You were correct! Thanks.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
11-29-2016, 09:32 AM
|
#7 | ||||||
|
can't tell until I see, but I can take care of it all, my work is warranty and will not alter original look of the gun even if I have to make a new part.
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Paweł Janusz For Your Post: |
|
|
|
12-03-2016, 12:08 AM
|
#8 | ||||||
|
Thank you for your offer. I figured out the problem. The bolt was upside down. I saw your case hardening pictures. What do you charge to prep the metal and do the case hardening?
|
||||||
|
|
|
||||||
|
|
|
|
|
|
11-29-2016, 10:42 PM
|
#9 | ||||||
|
Here is the update. Got the gun back and it works perfectly now. Turns out there is a flat metal key or plate inside where the lifter slides. It can be assembled one of two ways. The gunsmith put it in reversed the the first time. Now everything is good to go. Thanks for everyone's input. I will post again with the next issue under a new topic.
|
||||||
|
|
|
||||||
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode