New barrels in the white, Remington maybe?

[B. Dudley]

The biggest challenge with fitting up and using barrel sets like this is the rib and rib extension and the matting. There is no one that can matte the ribs.

I have found it easier to just remove the new rib completely and install a used rib and extension from another barrel. The issue here is finding one the right length with the desired barrel steel type marked on it.

[Dean Romig]

Originally Posted by Brian Dudley

The biggest challenge with fitting up and using barrel sets like this is the rib and rib extension and the matting. There is no one that can matte the ribs.

The rib matting can be engraved. Yup, full length engraved matting has been done.





.

[B. Dudley]

Originally Posted by Dean Romig

The rib matting can be engraved. Yup, full length engraved matting has been done.

I would like to see the results...

[Parker Bachelder (Brad's Profile)]

The matting can be cut by CNC as well. We have the program but are not set up to run it. We do have pre-profiled 28" ribs with blank address lines. They are very close to original looking.

Brad

[Bill Murphy]

Oh, Brad, Brad, Brad. We would demand 32" or 34" ribs. Please comment.