Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Purchased a set of feeler gauges from an auto parts store. Roughed up the mating surfaces. Used Devcon as the adhesive. Held it in all place with a 3/8" drive socket extension wrapped in masking tape, wood blocks and a c-clamp. A small amount of sanding with a dowel wrapped in emory cloth was all that was needed to finish the fit. Tight on face, no shake, all is well.
Last edited by Bill Graham; 07-28-2016 at 02:24 PM..
Reason: Fixed a typo
The Following 2 Users Say Thank You to Bill Graham For Your Post:
Threaded Mode