|
 |
 |
|||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||
 |
 |
03-01-2016, 10:07 PM
|
#3 | ||||||
|
I think the rib matting was cut not pressed,that is why they could do that after the rib was installed.
|
||||||
|
|
||||||
 |
 |
 |
|
|
|
03-02-2016, 08:45 AM
|
#4 | ||||||
|
Scott, thank you for reminding me that rib matting is cut, not pressed. The inscription on solid ribs is pressed. By the way, yesterday was test fire day for the GHE Damascus vent rib gun. What a gun! Jared and Tom had shown me the gun a couple of times last year, but I couldn't pull the trigger until it went to auction. The gun has the characteristic factory overbore to .740, and chokes of .040 and .044.
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Bill Murphy For Your Post: |
|
|
|
03-02-2016, 09:02 AM
|
#5 | ||||||
|
Edgar and I both forgot that the rib matting is cut and not pressed. The rib on the GHE in question is apparently either original to the gun or installed very early in vent rib manufacture. I say this because the breech end of the rib is unlike any Parker vent rib I have seen. Not just unusual because it is installed on a curved breech receiver, which is fairly common, but the rib itself has a completely different treatment of stippling and engraving. I wish I had Kevin's very early BHE vent rib gun to compare.
|
||||||
|
|
|
||||||
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode