|
12-07-2015, 04:05 PM | #3 | ||||||
|
Those plug gauges are worthless when it comes to measuring old Parker chokes.
|
||||||
The Following User Says Thank You to Mills Morrison For Your Post: |
12-07-2015, 04:10 PM | #4 | ||||||
|
Are there any markings on the barrels that would indicate how they were originally choked from the factory?
|
||||||
12-07-2015, 04:20 PM | #5 | ||||||
|
No markings on the barrels. A Research Letter may tell you what load and pellet count was when the gun was originally ordered.
|
||||||
The Following User Says Thank You to Frank Cronin For Your Post: |
12-07-2015, 04:26 PM | #6 | ||||||
|
Trojans were standard full and full unless they were the rare special order. Almost all were stock hardware store guns. A 16 ga Parker full choke is about .028.
|
||||||
The Following User Says Thank You to Bruce Day For Your Post: |
12-07-2015, 05:27 PM | #7 | ||||||
|
To add to what Bruce posted, the bore diameter is usually the nominal 16 gauge reading of .665 plus or minus. If the factory letter shows full and full, the muzzle diameter should be very approximately .635.
|
||||||
Thread Tools | |
Display Modes | |
|
|