Finally! Glad to hear this topic coming up. The misinformation regarding barrel matting termination is one of the most pervasive issues for newcomers to collecting Parkers. I can't believe the number of times I have had to explain that it is a viable GUIDELINE, but not set in stone. No bar at the end, flag goes up! Then measure the bore diameter, the length of chokes, the actual barrel length, and if possible, check the factory production info. If the chokes are 4" or longer and the bore diameter is factory, it is likely the barrels are uncut. Even the letter can get it wrong on occaission.
There are factory original Parker barrels that are +/- 1/8" of what is stated or standard. 27 7/8" barrels are not necessarily cut, as is the case with 28 1/8" barrels. The internal dimensions of the bores and chokes are probably the clearest indicators, in my opinion.
That is why it pays to invest in a good, 15" or longer bore micrometer. Look at Hosford and Co. in Ann Arbor Michigan for some of the best shotgun barrel tools in the country. John Hosford is coming out with an incredible bore gauge that will measure 28ga. - 10ga. with no changing of heads, all one tool. His barrel wall thickness gauge is fully portable and accurate, best gauge on the market. Phone number 734 395 9818.
|
Hybrid Mode