SHOOTING 2 3/4 SHELLS IN A VH

[Dean Romig]

Troy, I have a 2-frame Parker DH with 2 9/16" chambers that I have shot a lot of 2 3/4" 'off the shelf' ammo in but my shoulder (and perhaps the gun too) prefer RST or low-pressure ammo. Your VH is a 1-frame and the wall thickness at the cones should be measured before choosing to shoot 'off the shelf' 2 3/4" ammo in it.





.

[Mark Garrett]

I always like the Idea of shooting the right ammo for the gun.

[William Davis]

B&P's 7/8 oz Competition one is a viable option for low recoil. At the SxS shoots around here it's probably the most often seen shell.

Not suggesting anything to anybody but I am not real concerned about pressure in my Fluid Steel 12 G Parker's that have had the barrels inspected as long as it's light shot load and modest velocity, Recoil and effect on stock wood I do pay attention to.

Opps looking back at your other post it's a 16 G. Almost no factory shell options for light 16's besides RST's which are very good shells. For some reason factory 16's are loaded nearly as heavy as factory 12's when they are much better off with 3/4 oz 1160 FPS loads.

Go to 16G.com forums for the scoop on 16 G loads. I load all mine using their data.

William

[Bill Murphy]

16 gauge shells that are described as 2 1/2 dram equivalent, 1 ounce loads are what you want for normal light weight prewar American double guns. Other than these, no other mass market shells are light enough for our guns. If you can't find these, you will have to go to boutique shells such as RST.

[Troy Miller]

Originally Posted by Bill Murphy

16 gauge shells that are described as 2 1/2 dram equivalent, 1 ounce loads are what you want for normal light weight prewar American double guns. Other than these, no other mass market shells are light enough for our guns. If you can't find these, you will have to go to boutique shells such as RST.

I did find a couple of federal game loads at 2 3/4 in 2 1/2 dram 1oz lead