Beginner here, with new to me Parker DH

[10 bore]

wow ,what a nice gun, If you didn't already post it, what is the lop and dah?
scott

[Cal Genereux]

Originally Posted by scott kittredge

wow ,what a nice gun, If you didn't already post it, what is the lop and dah?
scott

Truthfully I haven't measured either. I bought the gun as an heirloom/collectible and its fit for shooting wasn't a consideration. I will, however measure those tomorrow and post them here. Those are things I should know about this gun but don't. Thank you for asking.

[Cal Genereux]

A few more pics I haven't yet posted.









The last two show a flaw in the wood. I think it was created when put back together. It is difficult to see but a small piece is pushed up where it meets the frame. I'm not sure what I can do about it. It can't be pushed down as the frame is in the way. Suggestions welcome.

[Cal Genereux]

Is the choke noted on the flats somewhere?

[Cal Genereux]

Originally Posted by Cal Genereux

Truthfully I haven't measured either. I bought the gun as an heirloom/collectible and its fit for shooting wasn't a consideration. I will, however measure those tomorrow and post them here. Those are things I should know about this gun but don't. Thank you for asking.

Finally got around to it Scott, LOP is 14", DAC 2" and DAH 3" I may be off an eighth or so with either of the drop measurements but that's pretty close. Thanks for asking.

[Cal Genereux]

My gun was advertised as a "D" grade, is there a difference between the "D" and "DH"? I'm familiar with the E meaning ejectors but I didn't know about the plain "D" and I didn't find it referenced in the Parker Identification section. Thanks in advance.