Krieghoff K-32

[Carvel]

The Krieghoff gunsmith I use told me that any K32 with a serial number below about 2400 could have from very few to almost all remington parts and the rest Krieghoff parts. They are difficult to work on since all the parts have to fitted depending on which parts are used and where. I have shot K32's for 40 years and have never shot anything I liked any better. Carvel

[6pt-Sika]

Just got finished putting the pad on my K-32 !

I suspect down the road if I can shoot the gun well I'll refinish the stock and correct the couple small nicks I don't care for !

But before that I want to send the gun to Briley and have them install their "Thinline" flush choke tubes and a set of sub gauge tubes !

Here's the gun with the new Kick Eez pad installed . LOP is 13 15/16" .

[6pt-Sika]

Originally Posted by Carvel Whaley

The Krieghoff gunsmith I use told me that any K32 with a serial number below about 2400 could have from very few to almost all remington parts and the rest Krieghoff parts. They are difficult to work on since all the parts have to fitted depending on which parts are used and where. I have shot K32's for 40 years and have never shot anything I liked any better. Carvel

I was at Danny Pattons shop yesterday as I planned to swap out the stock and forened for a set he had . But after we removed my stock we found that none of his later K-32 or K-80 stocks would fit my reciever without some slight inletting . In the past I'd never seen that . All the K-80 and K-32 stuff I had tried to use on the K-32 I used to have slipped right on . Well I think one K-80 unsingle trap barrel needed to be fit to my old reciever , but I don't know how many other K-80 and K-32 barrels and stocks slipped right on that old gun . But that isn't the case with this new to me gun !

What gunsmith do you use , Pylinski , the guy in Jersey or Allem ?

[Bill Murphy]

I go to Ottsville, but not to have a stock fitted.

[6pt-Sika]

Originally Posted by Bill Murphy

I go to Ottsville, but not to have a stock fitted.

I've driven past the shop in Ottsville more then 50 times but never stopped . Was always on my way with friends from Doylestown to the Poconos for a weekend of drinking etc !

[Carvel]

I use Earnest Marlette in Winston Salem N.C. 1-336-456-1818. Some times it takes a while it get in touch with him but is very good and has all the parts. Carvel

[6pt-Sika]

Originally Posted by Carvel Whaley

I use Earnest Marlette in Winston Salem N.C. 1-336-456-1818. Some times it takes a while it get in touch with him but is very good and has all the parts. Carvel

I sent him an Aya O/U last summer to do some work on for a customer . Talked with him on the phone a couple times he seemed like a decent fellow .