Worn Hinge Pin?

[Double Play]

Originally Posted by chris dawe

I remember reading last year I believe, that some one stateside was gearing up to manufacture and sell new roll joints for Parker's ...I think it was Steve Bertram ?

That would be a fantastic way to go and something I'm trying to get my machinist friends to look at for me (when their time allows ).

Other than that...what Dean said .

Chris,
I made a roll joint for one of our members a few years ago just for the learning experience. I would have to say that it would not likely be a "cost effective" way to correct an off-face condition. I've had guns put back on face by adding material to the hook and redressing for a lot less than the cost of a new roll joint.

[chris dawe]

Originally Posted by Larry Frey

Chris,
I made a roll joint for one of our members a few years ago just for the learning experience. I would have to say that it would not likely be a "cost effective" way to correct an off-face condition. I've had guns put back on face by adding material to the hook and redressing for a lot less than the cost of a new roll joint.

True,but if you could set up to run out a couple dozen or more at a time it would offset the cost ,I'm sure there's a market ...all it would take would be the right guy with the right equipment ,Parker did it once and the reproduction crowd did it years later,and Galazan must be doing it now ...Just a thought I've always had .

Like others and you have said ,Tig and refit is the most economical ,I've done it many times ....I can't help but wonder though every time one comes across the bench .....Why could no body else ever realize that Dan Lefever's ball and socket was the cure to the problem ? simply ,bloody genius !