Ithaca NID 16 Ga.

Bob Jurewicz · 08-20-2014, 07:55 PM

Walter,
NID's should have the chokes stamped on the front of the barrel flats (0-1-2-3-4). If they don't match the current constriction then there is a problem.
Bob Jurewicz

OLD GEEZER · 08-21-2014, 12:37 AM

I have a Crass 16 Ga. Ithaca not a NID I finally figured out with the ser. no. of 14338 and it has 26 inch barrels. I will try and post photo's tomorrow. Thanks Thomas

OLD GEEZER · 08-29-2014, 07:30 PM

I took a couple photo's of gun but returned it to my friend and passed on buying it. Interesting butt plate and I was concerned it had cut barrels but could be wrong.The photo of the end of the barrels are with the bottom rib on top and you can see the bead reflecting off the table top. Thomas

OLD GEEZER · 08-29-2014, 07:32 PM

A couple more photo's

Bill Murphy · 08-29-2014, 11:32 PM

Nice gun. Bore micrometer $90.51 at Brownells. It will last a lifetime.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode