16 GA 2.5 INCH 1 OUNCE LOAD LOW PRESSURE

[gman]

I really don't know but when I get a chance later this week I will set it up beside my 12 or 28 and see if I can tell. I do know that there is no short kit for the Grabber. If we cannot figure it out might not be a problem to call the and see what they say or see if they will do it. They are very friendly.

[Mark Garrett]

Thanks Eric,

I know that they are permanent mods and it will be a dedicated press, which is fine with me ,

If you could look at them side by side that would be great . I thought about calling them to see if they could modify a 2 3/4 press also but then I think I might be better off just getting a new one from them . I think if I had one to look at I could figure it out , ( I don,t know any one close that has one either) Don't think it would be too complicated .

I appreciate all the Help !

Mark