The divider is fixed, parallel lengthwise to the case, and does not leave enough room for buttstock unless it was very very small, if at all. There is a "pocket" attached to one side of the inside divider that's about half the length of the case and would maybe hold a 2-pc cleaning rod?? There's just not enough room for a buttstock. If the divider was loose it would I think. No makers mark of any kind on it. It would definitely make an awesome fishing rod case for nice old bamboo rods in flannel bags.... 32.5" x 25/8" x 8" outside dimensions. Maybe it would hold a flat stocked .410 skeet single bbl skeet gun??
Whoa! Mr Robin L....thank you. the divider is indeed hinged at one end so it is a gun case after all. I'll have to see what I have that might fit. I suspect that a repeater would fit best given the length, but if my 32" hammer fits, it has a new home...
Hmmm... won't actually take 32" bbls. 31.5" max. Definitely has plenty of room for a shorter gun. I slid a 26" gun in and everything fit fine but the stock end has way too much room to slide around of course. I'd vote for a pump gun case as Kevin says... mystery solved I think.
Last edited by Richard Flanders; 02-10-2010 at 12:38 PM..
|
Threaded Mode